Driving Directions

Hy-Ten Plastics, Inc. 38 Powers Street, Milford, New Hampshire 03055 USA

From Boston:
Take I-93 and go North for approximately ten (10) miles and take Exit 37B I-95 S / RT-128 S toward Waltham. Continue on I-95,RT-128 5 miles and then take the US-3 North Exit. (Refer to: From Route 3 South or North (Nashua) direction)

From Route 3 South or North (Nashua):
Take Exit 7W or 8, bear right (westerly direction onto Amherst street/Route 101A) towards Milford. Go Approximately 10 miles to Milford, look for Lorden Plaza on the right (Osco Drug & Shaws Supermarket). Continue past the Plaza for approximately one (1) mile. Look for Ryan's Variety Store on the left; take the next left onto Powers Street. After crossing the rail road tracks, Hy-Ten Plastics is the second building on the left.

From Route 101 East (Keene, Peterborough, Monadnock Region):
Follow 101 East towards Milford. Take Route 101 By-pass (4-way intersection of Route 101 &101A); bear right onto the By-pass. Go through the traffic light (will see a State Police Barracks on the right). Take the second exit and bear left at the end of the ramp. Go through the traffic light by Lorden Plaza on the right (Osco Drug & Shaws Supermarket). Continue past the Plaza for approximately one (1) mile. Look for Ryan's Variety Store on the left. Take the next left onto Powers Street. After crossing the rail road tracks, Hy-Ten Plastics is the second building on the left.

From Route 101 West (Manchester, Portsmouth, Seacoast Area):
Follow 101 West toward Milford. Take the Milford/Nashua exit. Make a left at the light at the end of the ramp. Go through the traffic light at Lorden Plaza (Osco Drug & Shaws Supermarket). Continue past the Plaza for approximately one (1) mile. Look for Ryan's Variety Store on the left; take the next left onto Powers Street. After crossing the rail road tracks, Hy-Ten Plastics is the second building on the left.


Location and Maps

Company  |  Services  |  Hy-Ten Asia  |  Clean Room  |  Case Studies  |  Contact  |  Home
 
© 2006 Hy-Ten Plastics, Inc. All Rights Reserved
Technical comments and questions about this web site please send to Web administration